We've noticed the article involving How to Turn off the Water for Plumbing Repairs listed below on the internet and thought it made good sense to relate it with you on this site.
If you try to close the water off to your fixtures by utilizing an angle stop which doesn't work you will certainly have to close of the water main to make your repair service. There are also lots of various other reasons you could need to close the water main like repairing icy pipes, fixing leaks, replacing components or faucets.
Lots of people are not aware that they even have a water pipe valve right in their very own house as well as simply call a plumber of never end up doing the fixing until points obtain really poor because they simply do not know that closing the water pipe is really simple.
One of the most common locations a water pipe will be found in residence is in your boiler room, basement, or an eliminated panel in an area for your home.
When you locate the water main you will merely turn the shutoff clockwise to close all the water off in your home until you have actually ended up the repair. Some houses will certainly enjoy valve with a lever that you can pull as opposed to resort to shut the water off.
How to Find and Shut Off Main Water Shutoff Valve
Where is the main water shutoff valve located?
This is the million-dollar question. Your main water shutoff valve could be located in several different areas. If you have a home with a basement and crawlspace, it is probably located on an interior wall near the front of the house, where the water comes in from the water meter. In this case, it is most likely hiding in plain sight. If your home was built on a slab, the valve might be located near the hot water heater or inside your garage.
How to Turn Off Main Water Valve
Once you find the shutoff valve you will either hand turn it (clockwise for gate valves and perpendicular to the pipe for ball valves) or use the appropriate tool depending on the design.
If it is located inside your house, it will most likely be a gate or “wheel” valve that you’ll simply turn clockwise to stop the flow of water. Another way to shut off the water is to go to the water meter box. Just be careful not to mess with the city shutoff side of the meter.
Where are the isolation valves?
Isolation shutoff valves are much easier to locate. Most essential home plumbing fixtures have separate valves that control the water flow. Sinks, toilets, water heaters, and washing machines should have a small valve located near the plumbing that can easily shut off the individual water supply.
Simply turning the valve clockwise will turn off the water flow. Sink and toilet problems can be dealt with quickly by simply shutting off the supply this way. It’s always good to test the isolation valves periodically to make sure they are working properly.
Again, once your tighten the water shutoff valves and turn off the water, open up your hot and cold lines to release pressure and test if the water is indeed off.
Make it a priority to locate the water valves in your home – and keep plumbing problems from turning into costly repair situations.
https://happyhiller.com/blog/how-to-find-shut-off-main-water-shutoff-valve/
I hope you enjoyed reading our article about How to Turn Off the Water in an Emergency. Thanks a lot for taking a few minutes to read through our article post. For those who enjoyed reading our post please do not forget to share it. Thanks so much for going through it.
Call